Losung Automation Pvt.Ltd. is one of the leading organization in the field of Industrial Automation to provide automation solution


Automation

Home About us Training Products Panel Mfg. Application Andon Displays Robotics/SPMs Machining Division Contact Us Feedback
Automobile Applications

SQF Furnace


  • Using servos on X, Y, Z, axis for spot welding robots
  • spots are programmable through MMI
  • Interlock are also programmable
  • Earlier this operation was Carried manually,
    which has reduced operator fatigue for putting 20-30 spots

Spot Welding Automation

 
Diesel locomotive engine is tested at different speed which generates 0-4000VDC and the feedback of the voltage is taken and data is logged at different speed in PC.

Diesel locomotive engine



  • RPM of the Air Compressor is varied by Pressure Feedback
  • 20% to 30% Energy saving is achieved between 35 to 50 Hz

RPM of the Air Compressor

 
Electrical power steering Assembly is tested on this table which check the midpoint voltage, when the shaft of the steering is rotated and values are recorded at each degree and average is calculted and result is shown in Ok &NG

Electrical power steering  Assembly



Pokayoke during Assembly of axle if the opevator forgets to perform the desired operation in a particular station, then conveyor stops and hooter sound and when the operation is performed then conveyor restarts.For example:Torquing, Axle leak test confirmation
 
Door open,close Soaking,, Carborising,Difussion,Cooling, Hardening,Quenching sequence is controlled using PLC panels.


SQF Furnace



Sequence and sizing control in Grinder using PLC,Servo and MMI
Grinders, Grinding Machines
 
Sequence is controlled using PLC panels.


Broaching machines


Sequence control of Die open close, Injection,Cooling,Ejector, Die height Adjust sequence is controlled using PLC based panels
 
Sequence control of Die open close, Injection,Cooling,Ejector, along with pressure & speed sequence is controlled using PLC based panels



Sequence control of Die open close,,Ejector, sequence is controlled using PLC based panel and it can be interlock using Loadcell for monitoring pressing load.

 
Sequence control of job rotation,Triggering of wire feeder and Power source , sequence is controlled using PLC based panel




Operation sequence is controlled using PLC based panels

 
Leakage in the compoenent is checked using Ateq instrument . Operation sequence is controlled using PLC based panels





Operation sequence is controlled using PLC based panels along with Current Feedbak control of shotpeening operation.

 
Operation sequence is controlled using PLC based panels along with Tank level ,Ttemperature and pressure feedback.





Sequence control of Tyre mounting is controlled using PLC based panels


 
Operation sequence is controlled using PLC based panels along with Tank level ,Ttemperature and pressure feedback.




 


Site by SMARTech